Vigo VG06051 Manual do Utilizador

This Installation Guide uses the following symbols to indicate important information.Always observe the instructions indicated by these symbols.VIGO I

7TOP VIEWINSIDE OF THE SHOWER3 33FIG. 10FIG. 11117MODEL VG06051310E. INSTALLING THE DOOR1. Remove the rollers (#3) from the box, note that these ar

FIG. 1297471919THIS END MUSTLOOK INSIDE THESHOWER197FIG. 14FIG. 1356MODEL VG06051F. INSTALLING THE HANDLE1. Unscrew the handle holders from the handle

- WAIT 24 HOURS BEFORE USING SHOWER.- DO NOT ALLOW WATER TO DIRECTLY HIT DOOR SEAL STRIP.IMPORTANT!CLEANING INSTRUCTIONS FOR THE SHOWER CABIN AND DOOR

MODEL VG0605113

IMPORTANTROLLER ADJUSTMENTS TO ACCOMMODATE OUT OF SQUARE OPENINGS1. Loosen the hex screw to allow for movement. Then place the allen key in the small

The small hexhole on on theroller will befacing up on thisroller.MODEL VG06051ROLLER (3)WALLWALLSTRAIGHT WALLSROLLER "A"SMALL HEX HOLEDIRECT

MODEL VG06051WALL OUT OFPLUMBWALLTOP ANGLED WALLABTILTS IN AT TOP(EXAGGERATEDFOR PURPOSEOF DEPICTION)FIG. 3The small hexhole on on theroller will befa

MODEL VG0605117BOTTOM ANGLED WALLROLLER "A"SMALL HEX HOLEDIRECTIONROLLER "B"SMALL HEX HOLEDIRECTIONWALL DIRECTIONBOTTOM ANGLEDFIG.

SHOWER ENCLOSURE LIMITED LIFETIME WARRANTYEFFECTIVE JANUARY 1, 2010

MODEL VG06051NOTE: INSTALLATION MUST BE DONE BY A QUALIFIED, LICENSED PROFESSIONAL.GLASS THICKNESS 3/8"PLEASE READ INSTRUCTIONS BEFORE PROCEEDING

1. WALL MOUNTBRACKET ASSEMBLY9. HANDLE ASSEMBLY12. DOOR THRESHOLD16. STRUCTURAL RAIL3. ROLLERS20. GLASS SUPPORT19. DOOR SEAL STRIP7. DOOR23. PHILLIPS

MODEL VG06051ABDIMENSIONS 'A' AND 'B' INCLUDE GLASS, SEAL STRIPS AND HARDWAREC4A, B & C DIMENSIONS WERE MEASURED AFTER SHOWER

BEFORE INSTALLATION: If needed, remove the plastic layer of the base border. Do notremove the plastic layer off the plastic platform of the base. Wal

STUDSFIG.26MODEL VG06051 PREPARATION STEPS TO FOLLOW BEFORE INSTALLATION1. Remove the plastic layer from the base border (if needed). Do Not

FIG. 4PLATEHEXSCREWBRACKET BODY7. Place the side glass panel with the structural rail into desired position. Use the level to correct position asse

FIG. 6THIN GASKET410410TOP VIEW4TOP VIEWINSIDE OF THE SHOWEROUTSIDE OF THE SHOWER21INSIDE OF THE SHOWEROUTSIDE OF THE SHOWER15181818MODEL VG06051FIG.

FIG. 71516FIG. 8FIG. 98921PLATECORNERBRACKET12C. INSTALLING THE SMALL FRONT FIXED PANEL1. Align the small front fixed panel (#5) to the shower openi