Vigo VG06061 Manual do Utilizador

This Installation Guide uses the following symbols to indicate important information.Always observe the instructions indicated by these symbols.VIGO I

10MODEL VG06061FIG.7SEAL STRIP INSTALLATION DIAGRAM1310THIS SIDE MUSTLOOK INSIDE THECABINMAGNET3/8"[10mm]51015131413D. INSTALLING THE WATER

11MODEL VG06061HEX SCREWSIDE GLASSPANEL (4)DOOR (13)THINGASKETVIEW FROM THE TOPHINGE (8)OUTSIDE OFTHE CABININSIDE OFTHE CABINPLATE E. INSTALLING

F. INSTALLING SIDE GLASS PANEL (PART #5)1. Install the side seal strip (#6) to the wall side of the side glass panel (#5). Install the magneticsid

13MODEL VG0606121316G. INSTALLING THE SIDE & FRONT PANEL SUPPORT1. Install the support assembly (#3) onto the side glass panel (#4) approximately

I. APPLYING THE SILICONE1. Apply clear silicone caulking to the inside between the wall and side seal strip.2. Apply clear silicone caulk to the in

IMPORTANT! WAIT 24 HOURS BEFORE USING SHOWER DO NOT ALLOW WATER TO DIRECTLY HIT DOOR SEAL STRIPSMODEL VG0606115J. HANDLE INSTALLATION1. Asse

MODEL VG0606116

CLEANING INSTRUCTIONS FOR THE SHOWER CABIN AND DOOR PANELA. Use mild liquid household cleaners to keep metal surface bright and clean. Rinse well and

MODEL VG06061SHOWER ENCLOSURE LIMITED LIFETIME WARRANTYEFFECTIVE JANUARY 1, 2010

21234679111012138MODEL VG06061NOTE: INSTALLATION MUST BE DONE BY A QUALIFIED, LICENSED PLUMBER.GLASS THICKNESS 3/8"PLEASE READ INSTRUCTIONS BEFOR

31.2.3. SUPPORT ASSEMBLY4.SIDE GLASS PANEL7.GLASS SUPPORT8.HINGE ASSEMBLY12.DOOR HANDLEASSEMBLYDOOR BOTTOMSEAL STRIP15.13. DOOR6.SIDE SEAL STRIP9. BOT

ABCCDMODEL VG060614A, B, C & D DIMENSIONS WERE MEASURED AFTER SHOWER ENCLOSURE WASCOMPLETELY INSTALLED19 1/2"X71 5/8"15 1/2"X71 5/8

5MODEL VG06061FRONT GLASSPANELDOOR PANEL SIDE GLASSPANELFIG. 1 (GLASS CONFIGURATION DIAGRAM)5134FRONT GLASSPANELDOOR PANELSIDE GLASSPANEL4135LEFT SIDE

INSTALLATION STEPSA. INSTALLING THE BOTTOM RAIL6MODEL VG06061PREPARATION STEPS TO FOLLOW BEFORE INSTALLATION1. Remove the plastic layer from the base

STUDFIG.2FIG.3AB911THIS EDGE LOOKSOUTSIDE OF THE SHOWERTHIS EDGE LOOKSINSIDE OF THE SHOWER18FIG.2A7MODEL VG06061TOP REMOVES TOINSTALL 3/4&qu

B. HINGE INSTALLATION1. Clean the glass surface on the side glass panel (#4) where the hinges (#8) are to be installedwith rubbing alcohol.2. Po

9MODEL VG06061WALLSIDEC. INSTALLING SIDE GLASS PANEL (PART #4)1. Arrange glass to the preferred configuration. (see diagram on page 5) These