Vigo VG06012 Manual do Utilizador descarregar pdf

This Installation Guide uses the following symbols to indicate important information.

Always observe the instructions indicated by these symbols.

VIGO INDUSTRIES INSTALLATION GUIDE FOR

SHOWER ENCLOSURE (MODEL VG06012)

Instructions that, if ignored, could result in death or serious personal injury caused by

incorrect handling or installation of the product. These instructions must be observed for

safe installation.

Maintenance and other important non-personal injury and non-material damage instructions

or statements that should be observed.

It is highly advised to dry fit the unit prior to any installation.

IMPORTANT

SAFETY PRECAUTIONS!

WARNING!

The instructions for the following unit is based off of the Vigo brand shower base. The

instructions can not be provided for any other installation other than that of the Vigo brand.

The warranty will be voided if the following was not performed properly.

CAUTION!

1 2 3 4 5 6 ... 11 12

MODEL VG06012 10

Resumo do Conteúdo

Página 1

This Installation Guide uses the following symbols to indicate important information.Always observe the instructions indicated by these symbols.VIGO I

Página 2

10FIG.10H. APPLYING THE SILICONE1. Apply clear silicone caulking to the inside between the wall and side seal strip. Repeat for theother side.2. Apply

Página 3

CLEANING INSTRUCTIONS FOR THE SHOWER CABIN AND DOOR PANELA. Use mild liquid household cleaners to keep metal surface bright and clean. Rinse well and

Página 4

MODEL VG06012SHOWER ENCLOSURE LIMITED LIFETIME WARRANTYEFFECTIVE JANUARY 1, 2010

Página 5

Packing List1. Wall connector (1pc)2. Structural arm (1pc)3. Door (1pc)4. Side glass panel (1pc)5. Door magnetic seal strip (2pc)6. Side seal st

Página 6

31WALL CONNECTOR2STRUCTURAL ARM4SIDE GLASS PANELSIDE SEAL STRIP6GLASS SUPPORT7HINGE ASSEMBLY8BOTTOM RAIL9DOOR MAGNETICSEAL STRIP5BOTTOM CORNER JOINT11

Página 7

LEFT CORNERINSTALLATIONRIGHT CORNERINSTALLATIONDOORDOORDOOR PANEL SIDE GLASSPANELFIG. 1A (GLASS CONFIGURATION DIAGRAM)DOOR PANELSIDE GLASSPANELMODEL V

Página 8

5STUDFIG.1FIG.2AMODEL VG06012PREPARATION STEPS TO FOLLOW BEFORE INSTALLATION1. Remove the plastic layer from the base border (if needed). Do NOT

Página 9

FIG.2FIG.3THINGASKETS6WALLSIDEDOORSIDE18155AB911THIS EDGE LOOKSOUTSIDE OF THE SHOWERTHIS EDGE LOOKSINSIDE OF THE SHOWER#176MODEL VG06012B. INSTALLING

Página 10 - MODEL VG06012

12HEX SCREWSTWO HEX SCREWSFIG.6414171. Install the wall connector (#1)approximately two-thirds for the wall.[SEE FIG.6]2. Install the structural arm (

Página 11

103FIG.7SEAL STRIP INSTALLATION131/2"1/8"313HINGE OUTLINE545101331/4"45131038MODEL VG06012E. INSTALLING THE WATER SEAL STRIP1. Clean al

Página 12

VIEW FROM INSIDE OF THE CABINTHIN GASKETSHEX SCREWSPLATEFIG.8FIG.915F. INSTALLING THE HINGE1. Clean the glass surface where the hinges (#8) are to be